Digital Automotive Tester (DAT)
No. OTC-3545 |
Digital Automotive Tester (DAT) |
A digital multimeter that tests sensors and fuel & ignition systems, too! This is a
professional meter for professional service technicians. Not one of those off the
shelf things that was changed just a little bit. This is the first of its kind; made
specifically for us; to do the things we do all day, every day. Check it out!"
The new OTC Digital Automotive Tester (DAT) does everything a standard
multimeter does, then goes a step beyond. It does everything from a deluxe
ground test to measuring ignition kV! The dual display shows two readings
simultaneously. It measures 2.5"x1.5".
Four LEDs give you enhanced testing capabilities, even acting as Noid Lights
when connected to a fuel injector! |
The DAT's dual action selector wheel, the power button, and the
function buttons are conveniently located so you can move
leads and probes freely for one-hand operation! |
| Features: |
- Digital Multimeter- Autoranging for AC/DC volts, resistance, and amps;
measures duty cycle, frequency, temperature, and RPM; continuity and
diode test capabilities; MIN, MAX, Delta, Adjustable Logic Probe, and
much more.
- Battery Drain Test -Complete parasitic battery drain tester. Also includes a
self-calibration feature.
- Electrical System Test - Look for bad grounds, voltage drops, intermittent
connections, or sources of high resistance. You can even run a charging
system test for diagnosing alternators and battery state.
- Sensor Tests - Get a quick and accurate diagnosis of the complete O2
circuit. The DAT is capable of sending a Rich/Lean signal to the ECM,
and displaying crossing-per-second and O2 voltage simultaneously.
Includes a glitch capture feature so you can identify any dropouts through
the range of a TPS sensor. Also includes a custom setup for MAP, MAF,
EGR, Crank, and Magnetic sensors.
- Fuel System Tests - The LEDs act as Noid Lights when the DAT is
connected to a fuel injector. You can also measure injector on-time and
peak voltage simultaneously. A dedicated mode reads line pressures with
the pressure adapter (available separately).
- Ignition System Test - The DAT is also a complete on-board kV tester.
You can measure Peak Voltage or Burn Voltage with Burn Time
simultaneously. Read RPM on 2-and 4-stroke engines. The Dwell option
lets you select number of cylinders.
|
All features are included: Volts, Ohms, Amps, BATT, ELEC, SEN, FUEL,
and IGN. The kit includes the ignition DAT leads as shown.
|
|
